Aritronix Scorpio Betriebsanweisung PDF herunterladen (Seite 7)

Ignition Disable / Anti-hijack Module (RID-5)

Installation

1. Cut the Ignition / Engine control wire (refer to options)

2. Attempt to start bike to test if correct wire is selected. If bike starts the wrong wire is selected.

(contact Aritronix for assistance) If bike does not start, correct wire was selected continue to

step 3.

3. When packaged the RID-5 wire ends have been treated with clear silicon to protect the ends

from fraying. Make sure they are stripped bare of this before continuing.

4. Connect one end of the cut wire to one of the blue tabbed wires in RID-5 with provided butt

connector or any other solid connection option.

5. Connect second end of the cut wire to second blue tabbed wire in RID-5 with provided butt

connector or any other solid connection option.

6. Test connections to insure that they are as solid as possible. *

7. Plug the RID-5 connector into the matching connector on the Accessory Harness.

8. Test RID-5 by activating alarm (without perimeter sensor) and try to start bike. If bike starts,

please contact Aritronix for assistance.

* Failure to test for a loose wire could cause an accidental engine cut off.

Color Codes:

(Color codes are not always valid. Always verify before making connections)

Ground (-) Tail Light Left Turn Signal Right Turn Signal

Honda Green Brown Orange Blue

Kawasaki Black Red Green Grey

Suzuki Black/White Brown Green or Black Grey

Yamaha Black Blue Green Brown

Harley Davidson Black Blue Brown Purple

Ducati Black Yellow White/Black White/Green

Using the T-tap Connectors and GEN-1 Connector

1) Place the female T-tap connector over wire, close and squeeze until it snaps.

2) Slip male T-tap connector over hinged end of the female connector to make a connection.

Motorc

cle Wire

Female T-ta

)

Motorc

cle Wire

Wire from (GEN-1

)

Female T-ta

Male T-Tap (GEN-1

)

--------------------- Skip this page if using Factory Connector Kit --------------------

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Keine Kommentare

Aritronix Scorpio Betriebsanweisung Seite 7