
Press button
4 to scroll
between the
sensor icons
Press button 1 to
toggle between
sound and
duration
settings
Press button 2
to adjust
selection
Seconds
Press button 2 to
adjust between
On/Off or 1-5
sensitivity levels
Press button 1 to
toggle between
On/Off and
sensitivity levels
Press button 4 to
save and exit
On/Off Sensitivity
Level
Press button 4 to
save and exit
11
Selecting Siren Tone and Alarm Duration (proximity to MCM required)
Enter the programming mode. Scroll to the icon and press button 1 to select. The screen will
display all of the sensor icons. To program follow these steps:
Adjusting the ADL202 Accelerometer (Impact/Shock) Sensor (proximity to MCM required)
Enter the programming mode. Scroll to the icon and press button 1 to select. The screen will
display the current shock setting, and the siren will chirp 1-5 times to confirm sensitivity level. To
program follow these steps:
Press button 1 to
select sensor
icon
Tone
Note. There are 5 siren tones
and 3 cycle duration
settings for each
sensor
Sensitivity level
Least 1
5 Most
16
Transceiver Battery Information
The receiver is automatically turned on whenever the system is armed. To conserve battery the
transceiver should be turned off when not in use, or when it’s out of range for extended periods of
time.
Low Battery Stages
It’s recommended that the transceiver be charged daily when in regular used. If the transceiver is
not charged daily the following stages will occur.
Low Battery: When the battery is low the
icon will cycle from 3 bars to 2 bars to 1 bar.
The transceiver should be charged as soon as possible.
Receiver Turns Off: If the transceiver is not charged, at some point (approximately 7 days) the
receiver will shut off. At this stage the LCD displays [CHRG BATT PAGE OFF] and
there are no bars in the
icon.
No Response: If the battery is not recharged and all power is drained. The transceiver will not
respond. The transceiver has to be charged before it can operate the system
again. At this stage the LCD displays [CHRG BATT PAGE OFF] and the no-
bar icon
will flash.
Kommentare zu diesen Handbüchern