Aritronix Scorpio Betriebsanweisung Seite 1

FCC Notice This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmfu

Press button 4 to scroll trough programmable options Press button 2 to adjust hour or minutes Press button 1 to toggle between hour and minutes. Pres

Press button 2 to scroll between the alert options Alert options include: alert off, vibrate, audible, vibrate and audibl

Press button 4 to scroll between the sensor icons Press button 1 to toggle between sound and duration settings Press button 2 to adjust selection S

15 RCS (Range Confirmation Signal) If the transceiver is within range of the MCM and the alarm is activated then the LCD will display icon. If the tra

13 Sensor Memory Display When the system is disarmed the turn signals will flash to indicate if there has been an alarm trigger. The lights will f

1 Installation Component List 3 Planning the Installation 3 Installation Diagram 4 Installation Warnings and Not

a1 Problem Possible Cause Solution Will not arm Key pad is locked Unlock key by holding button 4 for four seconds Power or ground not connec

3 Components Component Check List

4 AntennaTo Battery (+)Perimeter SensorIgniton DisableMain Control Module (MCM-55)Factory Conenctor KitGeneric Connecto

Extension 12” Antenna 6” 5 Note: Connect the (HAR-1) harness to the MCM only after installation is completed. Note: When the main harness (HAR-1) i

20 Ignition Disable / Anti-hijack Module (RID-5) Installation 1. Cut the Ignition / Engine control wire (refer to options) 2. Attempt to start bik

Battery Shock Trigger Perimeter TriggerClock Signal Indicator Alert Type Aud/Vibr System Status Button 3 Button 2 Button 1 Tilt

Perimeter Sensor (SN-5) Mounting the SN-5 The Perimeter sensor uses high frequency microwave technology to detect mass density movement around the mo