Aritronix Scorpio Betriebsanweisung PDF herunterladen (Seite 5)

a1

Problem Possible Cause Solution

Will not arm

RFID antenna not connected

Verify connection from MCM to RFID

antenna

Power or ground not connected

Verify connection to power lead and

ground connection

Orange wire not connected

Verify connection to 12 volt wire with

key on. (tail light on most bikes)

Turn signals will not

flash

Grey wires from GEN-1 not

connected or connected to wrong

wires

Test wires and change connections

to correct wires

Perimeter Sensor not

working

Sensor not connected Check connections

System set on default with sensor

off

Enter Programming mode and

change default

Ignition Disable does

not work

Orange wire from GEN-1 not

connected

Connect orange wire from GEN-1 to

12 volt (+) with ignition key on. In

most bikes that is the tail light wire

Ignition disable not connected to

correct wire on bike

Refer to options on the ignition

disable instruction page. Test

selected wire before reconnecting

RID-5 wires.

Troubleshooting guide

2

Manual Override Procedure

Programming Personal

Override Code 14

Enter Programming Mode 14

Select number of flashes for Code 14

Using Code in case of lost remote 14

Transceiver Information

Alarm Triggers 15

Range Confirmation Signal 16

Checking Violation Display 16

Transceiver Battery Information 17

Low Battery Stages 17

Optional Accessory Instructions

Perimeter Sensor (SN 5) 19

Back up Battery 20

Ignition Disable / Anti hijack Unit 21-22

Appendix

Trouble Shooting guide a1

Limited Warranty a2

Important Information / Notes a3

FCC Information a3

Special Note a3

1 2 3 4 5 6 7 8 9 10 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare