Aritronix Scorpio Betriebsanweisung Seite 1

www.scorpioalarms.com [email protected] Phone (480)951-1109 Aritronix Ltd 16055 N. Dial Blvd. Suite B-10 Scottsdale, AZ 85260

Battery Shock Trigger Perimeter Trigger 24 hour Clock / Text display Range Indicator Alert Type Aud/Vibr System Status Button 2 Button 1 Ti

Perimeter Sensor (SN-5) Mounting the SN-5 The Perimeter sensor uses high frequency microwave technology to detect mass density movement around the mo

Press button 2 again to scroll through programmable options Press button 1 to scroll between the options Programming and Customizing Instructions E

17 Transceiver Battery Information The receiver consists of two functions RFID functions and Two-way FM communication. Low Battery Stages It’s rec

Press button 1 to scroll between the options Press button 1 to adjust each digit Press button 2 to toggle between digits Press button 2 pass last digi

15 Alarm Triggers When the system is triggered, the siren will sound and the turn signal lights will flash. The transceiver’s LCD will display th

13 Sensor Memory Display When the system is disarmed the turn signals will flash to indicate if there has been an alarm trigger. The lights will f

FCC Notice This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmfu

1 Installation Component List 3 Planning the Installation 3 Installation Diagram 4 Installation Warnings and Not

a1 Problem Possible Cause Solution Will not arm RFID antenna not connected Verify connection from MCM to RFID antenna Power or ground not connect

3 Components Component Check List

4 --------------------- Installation Diagram --------------------

Extension 12” Antenna 6” 5 : Connect the (HAR-1) harness to the MCM only after installation is completed. Make sure remote is closed to bike

21 Ignition Disable / Anti-hijack Module (RID-5) Installation 1. Cut the Ignition / Engine control wire (refer to options on page 22) 2. Attempt t